Case No. 03 · Commissioning
Automatic packaging line for chipboard packages
Complete PLC/HMI development, installation support, commissioning and documentation of an automatic transport and packaging line for chipboard packages.
Task
The customer provided the technical specification, circuit diagrams and a description of the line function. Based on this, the control system, visualization and logic for automatic transport of chipboard packages were developed.
Technical data
- Siemens S7-1215
- Siemens HMI 7”
- TIA Portal / WinCC
- PROFINET
- 5 transport conveyors
- Rotary table
- Signal exchange with a third-party system
What was implemented
- Complete PLC program development in TIA Portal
- Creation of the Siemens 7” HMI interface
- Setup of PROFINET and signal exchange with a third-party system
- Support with electrical installation and cable routing on site
- Connection of motors and checking of actuators
- Commissioning of all operating modes
- Optimization of program and HMI according to customer requirements
- Preparation of a complete operating manual
Result
- The line was fully commissioned
- Automatic mode runs reliably
- The customer accepted the machine
- Documentation and operating manual were handed over
Photos and Videos
★★★★★
RomanCommissioning Siemens / TIA PortalGood specialist. He created the software in TIA Portal, responded to all comments, came to the site and helped with installation. He adjusted the program and, most importantly, prepared the documentation for the automation system. Highly recommended.